Greensmaster 3300/3400Hydraulic System Page 5 -- 4
General Information
Operator’s Manuals
The Traction Unit and Cutting Unit Operator’s Manuals
provide information regarding the operation, general
maintenanceproceduresandmaintenanceintervalsfor
your Greensmaster machine. Refer to these publica-
tions for additional information when servicing the ma-
chine.
Check Hydraulic Fluid Level
ThehydraulicsystemonyourGreensmastermachineis
designed to operate on high quality hydraulic fluid.
Check level of hydraulic fluid daily. Refer to Traction
Unit Operator’s Manual for fluid level checking proce-
dure and hydraulic oil recommendations.
1. Hydraulic reservoir 2. Fuel tank
Figure 1
2
1
Pushing Traction Unit
In case of emergency, your Greensmaster can be
pushed for a very short distance. However, Toro does
not recommend this as a standard procedure.
1. Make sure that engine is not running.
2. Locateby--passvalveonpiston(traction)pump(Fig.
2). Rotate by--pass valve so slot is vertical.
IMPORTANT: Do not push the machine faster than
2mph(3.2kph)becausethetractionsystemmaybe
damaged.Ifmachinemustbemovedaconsiderable
distance (more than a few feet), transport it on a
truck or trailer.
3. Slowly push machine.
4. Before starting engine, rotatepiston(traction) pump
by--pass valve so slot is horizontal. Do not start engine
when by--pass valve is in the vertical position.
1. Piston (traction) pump 2. By--pass valve
Figure 2
1
2
To Next Page
Loading...
