Greensmaster 3300/3400 Page 1 -- 3 Safety
While Operating
1. Sit on the seat when starting and operating the ma-
chine.
2. Before starting the engine:
A. Sitontheseat,makesurecuttingunitsaredisen-
gaged.
B. Verify that functional control lever is in neutral.
C. Verify that parking brake is applied.
D. Proceed to start engine.
E. Afterengineisstarted,releaseparkingbrakeand
keepfootofftractionpedal.Machinemustnotmove.
If movement is evident, the traction pedal linkage is
adjusted incorrectly; therefore, shut engine off and
adjust traction pedal linkage until machine does not
move when traction pedal is released.
3. Do not run engine in a confined area without ade-
quate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
4. Donottouchengine,exhaustsystemcomponentsor
radiator(ifequipped)whileengineis runningorsoonaf-
ter it is stopped. These areas could be hot enough to
cause burns.
5. Before getting off the seat:
A. Make sure cutting units are disengaged.
B. Verify that functional control lever is in neutral.
C. Apply the parking brake.
D. Stop the engine and remove key from ignition
switch.
E. Toro recommends that anytime the machine is
parked (short or long term), the cutting units should
be lowered to the ground. This relieves pressure
fromthehydraulicliftcircuitandeliminatestheriskof
cutting units accidentally lowering to the ground.
F. Donotparkthemachineonslopesunlesswheels
are chocked or blocked.
Safety
To Next Page
Loading...
