Toro GROUNDSMASTER 3000-D - Lubrication Procedures; Greasing Bearings and Bushings

19
LUBRICATION
CAUTION
Before servicing or making adjustments to the
machine, stop engine and remove key from
the switch.
GREASING BEARINGS AND BUSHINGS
(Fig. 15-20)
The machine has grease fittings that must be
lubricated regularly with No. 2 General Purpose
Lithium Base Grease. If machine is operated under
normal conditions, lubricate all bearings and bushings
after every 50 hours of operation or immediately after
every washing.
The grease fitting locations and quantities are:
2 Wheel Drive Models only-Steering cylinder ball
joint, Rear axle tie rod (2), Rear axle pivot (1) Rear
Spindle Shafts (2) (Fig. 15).
4 Wheel Drive Models only-Steering cylinder ball
joints, Rear axle tie rod (2), Rear axle pivot (1), Double
Cardan joints (2 ea. side) (Fig. 16) and Rear DrIve Shaft
(3) (Fig.17)
All Models-Intermediate Drive Shaft (9) (Fig. 18);
Pedal Pivots (5), Traction pedal (In square tube under
floor plate) (1) (Fig. 19) and Lift arm pivot (2) (Fig. 20).
Figure 15
Figure 16
Figure 17
Figure 18
(4)
(4)
Figure 19
Figure 20