29
BRAKE MAINTENANCE
ADJUSTING SERVICE BRAKES (Fig. 35)
If excessive pedal travel is required to engage brake or
as brake pads wear, an adjustment to the brake
linkage may be required.
1. Jack up front of machine and support with jack
stands.
2. Remove left front tire.
3. With brake linkage bellcrank against frame stop,
loosen jam nut disconnect clevis from bellcrank and
adjust linkage until there is a slight drag on rotor.
4. Back off clevis one full turn and reinstall to
bellcrank.
5. Tighten jam nut.
6. Repeat procedure on opposite wheel.
Figure 35
1. Bellcrank
2. Frame stop
3. Linkage Clevis
1
2
3
To Next Page
Loading...
