Toro GROUNDSMASTER 325-D - Nozzle Leakage Test (Mitsubishi K3 D)

TORO GM 325-D Mitsubishi K3D Diesel Engine
Notes
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
________________________________________________________________________________________________________________
31
1. Nozzle Leakage Test.
• The leakage test checks the nozzle tip for proper sealing.
• A leaking nozzle should be repaired or replaced.
2. Operate the pump until 1500 psi (108 kg/cm²) is reached, maintain this pressure.
3. Check the nozzle end.
• If the nozzle end is dry or a slight film of fuel is present, the nozzle is OK.
• If a drop of fuel forms or the nozzle drips fuel, the nozzle must be serviced or replaced.