Groundsmaster 3500--D Hydraulic System (Rev. D)Page 4 -- 67
Removal
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
WARNING
Before jacking up the machine, review and follow
Jacking Instructions in Chapter 1 -- Safety.
2. Jack up front of equipment enough to allow the re-
moval of the front wheel.
IMPORTANT: DO NOT hit wheel hub, wheel hub pull-
er or motor with a hammer during removal or instal-
lation. Hammering may cause damage to the
hydraulic motor.
3. Remove tire and wheel assembly, wheel hub, and
brake drum from the hydraulic motor. Remove brake as-
sembly, brake bracket, and wheel shield from the frame
(see Front Wheel and Brake Removal in Chapter 6 --
Wheels, Brakes, and Miscellaneous).
4. Remove wheel motor from frame using Figure 44 as
guide.
Installation
1. Install wheel motor to frame using Figure 44 as
guide.
2. Install wheel shield, brake bracket, and brake as-
sembly to the frame. Install brake drum, wheel hub, and
tire and wheel assembly to the hydraulic motor (see
Front Wheel and Brake Installation in Chapter 6 --
Wheels, Brakes, and Miscellaneous).
3. Lower the machine to the ground.
SafetyProduct Records
and Manuals
Kubota
Diesel Engine
Hydraulic
System
Electrical
System
Wheels, Brakes,
and Chassis
To Next Page
Loading...
