Toro Groundsmaster 4100-D 30411 - Page 35

Duetotheoperatingconditionsthesebearing/seal
packagesaresubjectto(i.e.sand,turfchemicals,water,
impacts,etc.)theyareconsiderednormalwearitems.
Bearingsthatfailduetocausesotherthandefectsin
materialsorworkmanshiparetypicallynotcovered
underwarranty.
Note:Bearinglifecanbenegativelyaffectedby
improperwashdownprocedures.Donotwash
downtheunitwhenitisstillhotandavoiddirecting
high-pressureorhighvolumesprayatthebearings.
Thegreasettinglocationsandquantitiesare:
TractionUnit
ServiceInterval:Every50hours
•Brakeshaftpivotbearings(5)(Figure34)
•Tractionpedalpivotbushing(1)(Figure35)
•Frontandrearaxlepivotbushings(2)(Figure36)
•Steeringcylinderballjoints(2)(Figure37)
•Tierodballjoints(2)(Figure37)
•Kingpinbushings(2)(Figure37).
Thetopttingonthekingpinshould
onlybelubricatedannually(2pumps).
Figure34
Figure35
Figure36
Figure37
CenterCuttingUnit
•Upperlinkpivot(4)(Figure38)
•Lowerlinkpivot(4)(Figure38)
•Latchpivot(2)(Figure38)
Note:Deckmayhavetoberaisedtoexposethegrease
ttingsforthelowerlinkpivotandthelatchpivot.
•Castorforkshaftbushings(2)(Figure39)
•Spindleshaftbearings(3)(Figure40)
•Idlerarmpivotbushings(2)(Figure40)
35