Toro Groundsmaster 4500-D Series - Page 226

Removal(continued)
7.Placecoverondeckspindleopeningtopreventcontamination.
8.Ifhydraulicttingsaretoberemovedfromdeckmotor,markttingorientation
toallowcorrectassembly.RemovettingsfrommotoranddiscardO-rings.
Installation
1.Ifttingswereremovedfromdeckmotor,lubricateandplacenewO-rings
ontottings.Installttingsintomotorportsusingmarksmadeduringthe
removalprocesstoproperlyorientatettings.Tightenttings(seeInstalling
theHydraulicFittings(SAEStraightThreadO-RingFittings)(page5–9)).
2.Removecoverfromdeckspindleopening.
3.Alignsplinesonmotorshaftandspindleshaft.Positionhydraulicmotorto
thecuttingdeck.
4.Securemotortocuttingdeckwithtwo(2)socketheadscrewsandat
washers(Figure117).
5.Removecapsorplugsfromhydraulicttingsandhoses.Connecthydraulic
hosestodeckmotor(seeInstallingHydraulicHosesandTubes(O-Ring
FaceSeal)(page5–7)).
6.Afterassemblyiscompleted,verifythathydraulichosesandttingsarenot
contactedbyanymovingcomponents.
HydraulicSystem:ServiceandRepairs
Page5–124
Groundsmaster
®
4500-D/4700-D
19245SLRevA