22
Adjusting the Skids
After initial set up or if height-of-cut is changed, deck skids
should also be adjusted. Adjust skids by loosening flange
lock nuts (Fig. 15), positioning skid at specified height (see
chart) and re-tightening flange lock nuts.
Front Cutting Unit
All H.O.C.—3/8 to 1/2 in. above level surface
Outboard Cutting Units
1 in. H.O.C.—Skid positioned all the way up
1-1/2 to 3 in. H.O.C.—Skid positioned 1/2 to 1 in.
above level surface
3 in. and above H.O.C.—Skid positioned all the way
down
1
Figure 15
1. Skid
To Next Page
Loading...
