Groundsmaster 7200/7210Hydraulic System Page 4 – 66
42.If necessary, remove two (2) bearings from PTO
gear. Discard removed bearings. Remove retaining ring
from groove in PTO gear bore.
1. Bearing
2. PTO gear
3. Retaining ring
Figure 63
1
2
3
1
43.Remove two (2) plugs from transmission pump
housing. Remove and discard O–rings from plugs.
1. Socket head plug
2. Hex plug
3. Pump housing
Figure 64
1
3
2
44.Remove three (3) socket head screws that secure
both side covers to transmission pump housing.
45.Carefully slide side covers from trunnion shafts and
housing. Remove and discard O–rings from side cov-
ers.
46.Remove retaining rings that secure oil seals into both
side covers. Remove oil seals from side covers. Discard
seals.
1. Side cover
2. O–ring
3. Pump housing
4. Retaining ring
5. Oil seal
Figure 65
1
2
5
4
3
To Next Page
Loading...
