Toro Groundsmaster 7200 - Chapter 2 Product Records and Maintenance; Product Records; Maintenance

Groundsmaster 7200/7210 Page 2 – 1 Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1. . . . . . . . . . . . . . . . . . . . . . . . .
MAINTENANCE 1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
EQUIVALENTS AND CONVERSIONS 2. . . . . . . . . . .
Decimal and Millimeter Equivalents 2. . . . . . . . . . . .
U.S. to Metric Conversions 2. . . . . . . . . . . . . . . . . . .
TORQUE SPECIFICATIONS 3. . . . . . . . . . . . . . . . . . .
Fastener Identification 3. . . . . . . . . . . . . . . . . . . . . . .
Using a Torque Wrench with an Offset Wrench 3. .
Standard Torque for Dry, Zinc Plated and Steel
Fasteners (Inch Series) 4. . . . . . . . . . . . . . . . . . . .
Standard Torque for Dry, Zinc Plated and Steel
Fasteners (Metric Fasteners) 5. . . . . . . . . . . . . . .
Other Torque Specifications 6. . . . . . . . . . . . . . . . . .
Conversion Factors 6. . . . . . . . . . . . . . . . . . . . . . . . .
Product Records
Insert a copy of the Operator’s Manual and Parts Cata-
log for your Groundsmaster 7200 or 7210 at the end of
this chapter. Additionally, if any optional equipment or
accessories have been installed to your machine, insert
the Installation Instructions, Operator’s Manuals and
Parts Catalogs for those options at the end of this chap-
ter.
Maintenance
Maintenance procedures and recommended service in-
tervals for the Groundsmaster 7200 and 7210 are cov-
ered in the Operator’s Manuals. Refer to those
publications when performing regular equipment main-
tenance.
Product Records
and Maintenance