Groundsmaster 7200/7210Page 6 – 18Chassis
PTO Drive Shaft
1. Transmission assembly
2. Cap screw (4 used)
3. Roll pin (2 used)
4. Lock nut (4 used)
5. PTO drive shaft
6. Cutting deck gearbox
Figure 18
FRONT
RIGHT
2
3
4
5
1
6
2
3
4
175 to 225 in–lb
(20 to 25 N–m)
175 to 225 in–lb
(20 to 25 N–m)
WARNING
Do not start the engine and engage the PTO
switch when the PTO drive shaft is discon-
nected from the cutting deck (or implement). If
the engine is started and the PTO shaft is al-
lowed to rotate, serious personal injury and
machine damage could result. If the PTO drive
shaft is disconnected from the cutting deck (or
implement), remove fuse F1 (15 amp) from fuse
block to prevent unintentional engagement of
the PTO clutch.
To Next Page
Loading...
