Toro Groundsmaster 7200 - Page 95

Groundsmaster 7200/7210 Hydraulic SystemPage 4 – 59
12.Remove three (3) shorter (45 mm) and two (2) longer
(95 mm) flange head screws that secure pump body to
center case. Remove pump body from center case.
1. Pump body 2. Center case
Figure 45
2
1
13.Remove two (2) pins that locate pump body. Remove
and discard O–rings.
1. Pin 2. Pump body
Figure 46
2
1
1
14.Slide outer and inner charge pump rotors from RH
pump shaft. Remove key from keyslot in pump shaft.
1. RH pump shaft
2. Outer pump rotor
3. Inner pump rotor
Figure 47
2
1
3
Hydraulic
System