Toro GT Classic 73450 - Setup; Loose Parts; Checking the Tire Pressure; Activating the Battery

12
Setup
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Hitch Pin
Hairpin Cotter – 1-7/8 in.
Flat Washer – 1/2 x 1 in.
1
1
1
Installing the hitch pin
Bolt – 1/4 x 3/4 in.
Hex Nut – 1/4 in.
2
2
Attaching the battery cables
Hairpin Cotter – 1-7/8 in.
Flat Washer – 1/2 x 1 in.
1
1
Attaching accessory to lift bar
Operator’s Manual
Set Up Instructions
Riding Mower Safety Video
1
1
1
Read before operating tractor
Read before setting up tractor
View before operating tractor
Checking the Tire Pressure
Check the front and rear tire pressure. The correct front
and rear tire pressure is 12 psi (83 kPa).
Activating the Battery
Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
Danger
Battery electrolyte contains sulfuric acid which is
a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and robber gloves to protect
your hands.
• Fill the battery where clean water is always
available for flushing the skin.
• Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the tractor.
2. Clean the top of the battery with a paper towel.
Note: Never fill the battery with electrolyte while the
battery installed in the tractor. Electrolyte could be spilled
on other parts and cause corrosion.
3. Remove the vent caps from the battery (Fig. 2).