Manual Valve
Use this feature to start one or more valves, watering sequentially, for a selected period of
time.
1. Set the dial to the Manual Valve position.
2. Valve 1 will show on the display. You may use + and – buttons to select the amount of
time for valve 1 to water or you may skip to the next valve by pressing the Next button.
3. Select the valves to water and their watering duration by repeating Step 2 for the
remaining valves.
4. If using a master valve or pump, press the Next button until MASTER is displayed (after
last valve). Press the + button. This opens the master valve while the other valves are
watering.
5. Set the dial to the Run position. Valves will water sequentially for the set time with the
operating valve scrolling on the display periodically during its manual watering
operation.
6. If desired, you may turn the dial to Off position for longer than three seconds to
discontinue the manual valve operation. Always return dial to Run position to enable
automatic watering.
11
To Next Page
Loading...
