Multi Pro 1200/1250 Page 6 -- 33 Spray System
Disassembly (Fig. 33)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Remove pressure control valve from machine (see
Spray Control (Multi Pro 1200) in this section).
2. Disassemble pressurecontrol valveusingFigure 33
as a guide. Discard all removed O--rings.
Assembly (Fig. 33)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. Assemble pressure control valve using Figure 33 as
a guide. Replace all removed O--rings.
2. Install pressure control valve to machine (see Spray
Control (Multi Pro 1200) in this section).
1. Pressure control valve
Figure 34
1
FRONT
Spray
System
To Next Page
Loading...
