Multi Pro 1200/1250 Page 7 -- 11 Drive Train
Service and Repairs
CVT Drive Belt Service
CVT Drive Belt Inspection
NOTE: Perform this maintenance procedure at the in-
terval specified in the Operator’s Manual.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Put vehicle transmission in neutral.
3. RotateandinspectCVTdrivebeltforexcessivewear
or damage. Replace belt as necessary.
CVT Drive Belt Replacement (Fig. 8)
1. To remove CVT drive belt:
A. While rotating the driven clutch, route belt over
the clutch.
B. Remove belt from the drive clutch.
2. To install CVT drive belt:
A. Place new belt around drive clutch.
B. Position belt to driv e n clutch. While rotating the
drivenclutch,routebeltintopositionondrivenclutch.
1. CVT drive belt
2. Driven clutch
3. Drive clutch
Figure 8
2
1
3
Drive Train
To Next Page
Loading...
