Toro Multi Pro 1200 - Page 196

Multi Pro 1200/1250Page 7 -- 34Drive Train
15.To remove shift arms:
A. Loosenandremovelocknuts(item3)thatsecure
shiftarms(items1and4).Removeflatwashers(item
2) and shift arms.
B. Loosen and remove cap screws (item 5). Re-
move lock washers (item 6) and keeper plates (item
7).
C. Remove oil seals (item 8) from transaxle case.
D. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
1. Shift arm (2--3)
2. Flat washer
3. Lock nut
4. Shift arm lever (1--R)
5. Cap screw
6. Lock washer
7. Keeper plate
8. Oil seal
Figure 44
1
3
4
5
6
7
8
2
8
7
6
5
3
2
16.Loosen five (5) cap screws (item 1) and remove nut
withwasher(item2).SeparateP.T.O.cover(item3)and
O--ring from transaxle case. Inspect P.T.O. cover for
cracks or damage and replace if necessary.
17.Ifnecessary,removeoilcap(item4)withO--ringfrom
transaxle case.
18.Ifnecessary,removeairbreather(item5)fromtrans-
axle case.
2
1
3
4
5
Figure 45
19.If necessary, remove cap screw with lock washer
(item1)andslidespeedsensor(item2)fromuppercov-
er (item 4).
20.Loosen and remove cap screws (item 3) that secure
upper cover to transaxle case. Remove upper cover
(item 4) from case.
Figure 46
2
1
3
4