Toro Multi Pro 1200 - Page 197

Multi Pro 1200/1250 Page 7 -- 35 Drive Train
21.Disassemble main shaft assembly:
A. Use a bearing puller to remove bearing (item 1)
from main shaft.
B. Remove snap ring (item 2) and thrust washer
(item 3). Measure thickness of thrust washer. Re-
placewasher ifitis lessthan0.0709” (1.8mm)thick.
C. Remove 36T gear (item 4) and two (2) needle
bearings (item 5). Inspect needle bearings and re-
place if necessary.
D. Remove synchro ring (item 6).
E. Remove retaining ring (item 7).
F. Remove synchro shifter (item 8) together with
springs, hub and three (3) keys.
G. Remove key (item 9).
H. Remove retaining ring (item 10).
I. Removesynchroring(item6),22Tgear(item11),
two (2) needle bearings (item 12) and thrust washer
(item 13). Inspect needle bearings and replace if
necessary.
J. Useabearingpullertoremovebearing(item14).
K. Remove 14T gear (item 15), retaining ring (item
16) and 20T gear (item 17).
1
2
3
5
4
6
8
13
15
7
10
11
12
9
18
17
16
14
Figure 47
1
2
3
5
4
6
8
7
10
6
11
12
13
9
18
17
16
15
14
Figure 48
Drive Train