Multi Pro 1200/1250Page 7 -- 42Drive Train
8. Inspectcenterplateforcracksanddamage.Replace
center plate if the retaining ring groove has more than
15% of its edges damaged due to nicks, rounding,
cracks or dents (Fig. 64 and 65).
UNDAMAGED
GROOVE EDGES
Figure 64
DAMAGED
GROOVE EDGES
Figure 65
9. Inspect reduction shaft:
A. Inspect reduction shaft for wear or damage. If
O.D. of needle bearing area is less than reject size
specified in Figure 66, replace the reduction shaft.
STD. O.D. 0.984” (25 mm)
Reject O.D. 0.982” (24.95 mm)
STD. O.D. 0.866” (22 mm)
Reject O.D. 0.864” (21.95 mm)
Figure 66
To Next Page
Loading...
