Toro Multi Pro 1200 - Transaxle Assembly

Multi Pro 1200/1250Page 7 -- 44Drive Train
Transaxle Assembly
NOTE: Item numbers in figures are shown in reverse
order of assembly; for example, when reassembling,
installitem1last.
IMPORTANT: Be careful not to damage mating sur-
faces when removing gasket material.
1. Clean gasket material from all transaxle mating sur-
faces before reassembling. Make sure all parts are
clean and free of dirt and dust.
2. Assembledifferentialcarrier(L.H.axleshaft)assem-
bly (Fig. 69):
A. Applymulti--purposegreaseonnewoilseal(item
7) and install seal into differential carrier (item 8).
B. Use a press to install bearing (item 6) onto L.H.
axle shaft (item 3).
C. Install washer (item 5) and retaining ring (item 4)
onto L.H. axle s haft. Make sure that retaining ring is
fully seated in axle groove.
D. Install L.H. axle shaft assembly into carrier.
E. Installretainingring(item2)intogrooveincarrier.
Makesurethat retaining ringisfully seatedincarrier
groove.
F. Applymulti--purpose greaseontoO--ring (item1)
and install O--ring onto carrier.
L.H. AXLE SHAFT
2
3
6
8
1
5
7
4
Figure 69
3. Assemble R.H. axle shaft (Fig. 69):
A. Apply multi--purpose grease on oil seal (item 5)
and install seal into seal cover (item 7).
B. Use a press to install bearing (item 4) onto R.H.
axle shaft.
C. Install washer (item 3) and retaining ring (item 2)
onto R.H. axle shaft. Make sure that retaining ring is
fully seated in axle groove.
D. Insert washer (item 6) into s eal cover.
E. Install R.H. axle shaft assembly into seal cover.
R.H. AXLE SHAFT
2
3
6
1
5
4
7
Figure 70