Multi Pro 1200/1250Page 7 -- 54Drive Train
18.Measure countershaft end play. Rotate one of the
axleshaftsbackandforthtotakeupallbacklash.Rotat-
ingtheshaftinone direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the r etaining
ringandshim(set)withafeelergauge. Make sureshim
set is pressed against the bearing during the measure-
ment. End play should be 0.000” to 0.0039” (0.0 to 0.10
mm) (Fig. 95).
IMPORTANT: If end play is too great, replace shim/
shim set (item 2) with thicker shims to allow correct
end play.
Figure 95
19.Insert sealing cap (item 1) flush with face of center
plate. Make sure not to insert sealing cap too far. Pay
attention to direction of sealing cap.
1
Figure 96
To Next Page
Loading...
