Multi Pro 1200/1250Chassis Page 8 -- 10
Rear Wheels and Brakes
1. Lug nut (5 used per wheel)
2. Flange head screw
3. Wheel assembly
4. Brake drum
5. Stub axle
6. Lock washer (5 used per wheel)
7. Drive stud (5 used per wheel)
8. Cap screw (4 used per wheel)
9. Lock washer (4 used per wheel)
10. Brake assembly
11. Brake cable clip
12. Axle housing assembly
13. Parking brake cable
14. End yoke
15. Yoke strap (2 used per yoke)
16. Bolt (4 used per yoke)
17. Flange lock nut
18. Flat washer
19. Flange head screw (3 per housing)
Figure 6
FRONT
RIGHT
55 to 65 ft--lb
(75to88N--m)
220 to 225 ft--lb
(299 to 305 N--m)
Loctite #271
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
4
Loctite #271
200 to 250 in--lb
(22.6 to 28.2 N--m)
40 to 60 ft--lb
(55to81N--m)
Removal (Fig. 6)
1. Parkmachineonalevelsurface,stopengineandre-
move key from the ignition switch.
2. Chockfrontwheels.Raiserearwheelusingajackor
hoist (see Jacking Instructions in Chapter 1 -- Safety).
Support raised machine with jack stands.
3. Loosen andremovelugnuts that secure rearwheel.
Remove rear wheel.
4. Loosen set screw on parking brake control lever
knob(Fig.7).Turnknobonparkingbrakelevercounter-
clockwise all the way to loosen brake cables.
5. To remove brake drum, it may be necessary to back
off parking brake adjuster. To back off adjuster, rotate
brake drum until access hole lines up with star wheel.
Use a hooked piece of wire to pull pawl away from star
wheel, then turn star wheel. Pull brake drum from ma-
chine.
1. Parking brake lever 2. Set screw
Figure 7
1
2
To Next Page
Loading...
