Toro Multi Pro 1200 - Page 247

Multi Pro 1200/1250 ChassisPage 8 -- 27
Removal (Fig. 21)
1. Parkmachineonalevelsurface,stopengineandre-
move key from the ignition switch.
2. Disconnect negative (--) cable and then positive (+)
cable from battery.
3. Remove seat assembly by tilting seat forward and
removing hitch pin and clevis pin (Fig. 22).
4. Remove screws that secure control panels to seat
base. Carefully place control panels into seat base
openings.
5. Remove knob from shift lever.
6. Remove eight (8) flange head screws that fasten
seatbasetomachine.Duringscrewremoval,locateand
remove washers and spacers. The two (2) screws di-
rectly behind the front wheels are secured with flange
nuts (item 7).
7. Carefully lift seat base from machine.
Installation (Fig. 21)
1. Position seat base on machine.
2. Carefully pull control panels through openings in
seat base.
3. Secure seat base to machine using washers,
spacers, flange nuts and eight (8) flange head screws.
Install all fasteners before tightening.
4. Install knob on shift lever.
5. Secure control panels to seat base.
6. Secureseatassemblytomachinewithclevispinand
hitch pin.
7. Connect positive (+) cable and then negative (--)
cable to battery.
1. Seat assembly
2. Hitch pin
3. Clevis pin
Figure 22
3
1
2
Chassis