Toro Reelmaster 216-D - Page 60

8
39
5
Figure 37
4. Lift out the cylinder block assembly (Item 5). The
5. Visually inspect wear surfaces of valve plate, cylinder
pistons may come out of the cylinder block. There is no
block and slippers for damage. Check to be sure pistons
special orientation of piston to bore that needs to be
are free in bores.
maintained. Do not attempt to disassemble the spring
and other parts from the center bore of the cylinder
6. Remove thrust plate (Item 39) from counterbore in
block. The entire cylinder block assembly (Item 5)
face of swashplate (Item 37). Visually inspect both sides
should be replaced if any of its components are dam-
for damage and flatness.
aged.
Repairs Page 5 - 34 Reelmaster
®
216/216-D