Figure 40
6. Install new pins through swashplate and shaft. Use
8. The swashplate should swing freely in the pump
two (2) pins in control shaft (Item 28), installing first pin
housing to 150° each side of center.
until second pin can be started, then driving in both pins
together until the last pin is 1/4 inch below swashplate.
7. Install one (1) pin in trunnion shaft (Item 12), driving
it in until it is 1/4 inch below swashplate.
Reelmaster
®
216/216-D Page 5 - 37 Repairs
To Next Page
Loading...
