39
5
Figure 41
9. Lubricate thrust plate (Item 39) with clean hydraulic 12. Slide cylinder block assembly (Item 5) over shaft and
oil and insert in counterbore of swashplate. engage spline. Be certain that pistons and thrust plate
remain in place. When properly installed a slight spring
10. Assemble cylinder block parts if necessary and
tension can be felt when pushing on cylinder block.
lubricate with clean hydraulic oil. There is no special
orientation of piston to bore that needs to be maintained. 13. Lubricate exposed face of cylinder block with clean
hydraulic oil.
11. Place the housing assembly in a horizontal position.
Repairs Page 5 - 38 Reelmaster
®
216/216-D
To Next Page
Loading...
