Toro reelmaster 216 - (Reelmaster 216 - S;N 19999 & Below); Brake Service; Repairs

Repairs
Brake Service (Fig. 5)
(Reelmaster 216 — S/N 19999 & below)
Figure 5
1. Park machine on a level surface. Jack up front of
machine and support under frame with jack stands.
Remove both front wheels.
2. Remove extension springs (Item 17, 21).
3. Remove cotter pin (Item 22). Remove spacer
(Item 23), bushing (Item 24) and brake shoe (Item 25)
from brake arm.
4. Remove capscrews and lockwashers to remove re-
turn spring bracket (Item 20) from brake shoe.
5. Replace parts that are worn or damaged.
6. After installing brake shoes, install extension springs.
NOTE: Stronger springs (Item 17) go on top.
7. Do steps 2 - 6 under Hand (Parking) Brake Adjust-
ment
(Reelmaster 216 - S/N 19999 & Below) in the Adjustments
section of this chapter.
Repairs Page 7 - 6 Reelmaster
®
216/216-D