Specifications
Width/Height of Cut: 72 in. (183 cm) width of cut. 5, 8,
or 11 blade floating: 1/4 – 1-3/4 in. (6.4 – 44.4 mm);
5 blade fixed: 1/2 – 2-5/8 in. (12.7 – 65.6 mm).
Frequency of Clip:
Standard Cutting Unit Drive Pulley
5 blade fixed or floating 8 blade floating 11 blade floating
@ 795 reel rpm @ 860 reel rpm @ 860 reel rpm
@ 4 mph (6.4 km/h) 1.06 in. (27 mm) .61 in. (15.5 mm) .45 in. (11.4 mm)
@ 5 mph (8 km/h) 1.32 in. (33.5 mm) .77 in. (19.5 mm) .56 in. (14.2 mm)
Optional Large Cutting Unit Drive Pulley
5 blade fixed or floating 8 blade floating 11 blade floating
@ 646 reel rpm @ 646 reel rpm @ 646 reel rpm
@ 4 mph (6.4 km/h) 1.31 (33.2 mm) .82 in. (20.8 mm) .59 in. (15 mm)
@ 5 mph (8 km/h) 1.64 in. (41.6 mm) 1.02 (25.9 mm) .74 in. (18.7 mm)
Height of Cut Adjustment: Positive position settings
with separate fine adjustments for leveling either end of
roller, or extending height range.
Bedknife To Reel Adjustment: Single knob screw
adjustment for bedknife to reel, located at center of
bedbar. Adjustment knob detent with .001 in. movement
of bedknife for each indexed position.
Bedknife Screw Torque: 200 in-lb.
Specifications Page 9 - 2 Reelmaster
®
216/216-D
To Next Page
Loading...
