Service and Repairs
Front Roller Installation (Fig. 11)
(Floating Cutting Units)
1. Remove (2)locknuts securing each angle bracket to
cutting unit.
2. Remove height-of-cut pins.
3. Insert smaller diameter. shaft end of roller into white
bushing in roller bracket, making sure flanged end of
nylon bushing faces inside toward roller. Hex of roller
bracket must mate with hex of nut adjustment.
4. Press roller bracket onto shaft end of roller. Hex of
roller bracket must mate with hex of nut adjustment.
5. Hold one roller bracket stationary and use other
bracket as a wrench to loosen or tighten bearing clear-
ance to allow roller to rotate freely and to eliminate
bearing end play.
6. Roller brackets must be aligned for installation onto
cutting unit. If necessary to align after bearing adjust-
ment, remove roller bracket on side with flanged nyliner,
align with opposite roller bracket within ± one hex flat
and replace.
7. Reinstall Height-of-Cut pins.
8. Reinstall (2) locknuts securing each angle bracket to
cutting unit.
Figure 11
1. Roller bracket 4. Support capscrew
2. Angle bracket 5. Locknuts
3. Height of cut pin
Service and Repairs Page 9 - 12 Reelmaster
®
216/216-D
To Next Page
Loading...
