Toro reelmaster 216 - (Fixed Cutting Units); (Floating Cutting Units); Installing Cutting Units

Installing Cutting Units (Fig. 12)
(Floating Cutting Units)
1. Slide a thrust washer onto lift arm pivot rod.
2. Slide cutting unit carrier frame onto pivot rod and
secure with a flat washer, lockwasher and capscrew.
Figure 12
1. Thrust washer
2. Carrier frame
3. Flat washer, lockwasher, capscrew
Installing Cutting Units (Fig. 13)
(Fixed Cutting Units)
1. Slide a thrust washer onto lift arm pivot rod.
2. Slide cutting unit support onto pivot rod and secure
with a flat washer, lockwasher, and capscrew.
3. Front cutting units should be parallel to front wheels.
To adjust, loosen capscrews securing supports to cut-
ting units, adjust cutting units until parallel, then, re-
tighten screws.
Figure 13
1. Thrust washer
2. Cutting unit support
3. Flat washer, lockwasher, capscrew
Reelmaster
®
216/216-D Page 9 - 13 Service and Repairs