Toro reelmaster 216 - Cutting Unit Setup and Adjustment; Set Height of Cut and Level Rear Roller

__________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
Specifications
Item Description
Pump (Fig. 1) Sauer-Sundstrand, variable axial piston pump
Charge pressure
70 - 150 PSI
Implement relief pressure
700 - 800 PSI
Wheel Motors Nichols-Gray, orbit rotor type
Lift Control Valve Spool type directional control valve
Hydraulic Filter Spin-on cartridge type, 25 micron
Hydraulic Oil * Mobil DTE 26 or equivalent
Reservoir
Reelmaster 216 (Fig. 2)
Approximately 3.5 gal. U.S.
Reelmaster 216-D (Fig. 3)
Approximately 3.3 gal. U.S.
GAUGE PORT
* Equivalent Hydraulic Oils
SYSTEM PRESSURE
(interchangeable):
GAUGE PORT
CHARGE PRESSURE
Shell Tellus 68
Amoco Rykon Oil 68
PORTS (2)
IMPLEMENT
Conoco Super Hydraulic Oil 68
Exxon Nuto H 68
Kendall Kenoil R & O AW 68
Pennzoil Penreco 68
Phillips Magnus A 68
Standard Energol HLP 68
Sun Sunvis 831 WR
Union Unax AW 68
INPUT SHAFT
Chevron AW Hydraulic Oil 68
INLET PORT
MOUNTNG FLANGE
CONTROL SHAFT
PORT A, PORT B
AND DRAIN PORT
Figure 1
1
2
Figure 2 Figure 3
(Reelmaster 216) (Reelmaster 216-D)
1. Dipstick filler cap 1. Sight gauge 2. Hydraulic reservoir cap
Specifications Page 5 - 2 Reelmaster
®
216/216-D