Toro reelmaster 216 - Cutting Unit Clutch (Reel Drive) Switch

Cutting Unit Clutch (Reel Drive) Switch (Fig. 11, 12)
Reelmaster 216 (S/N 19999 and below)
To test switch independent of wiring harness, discon-
nect wire harness connector(s) from switch terminals.
When the switch is ON (Engage), there should be
continuity between terminals A – B only. When the
switch is OFF (Disengage), terminals C – D and B – E
should show continuity.
Reelmaster 216
(S/N 20001 and up)
Reelmaster 216-D
To test switch independent of wiring harness, discon-
nect wire connector(s) from switch terminals. When the
switch is ON (Engage), there should be continuity be-
tween terminals 5 – 6 only. When the switch is OFF
(Disengage), terminals 1 – 2 and 4 – 5 should show
continuity.
1
Figure 11
(Reelmaster 216)
1. Cutting unit clutch (Reel) switch (Item 20)
1
Figure 12
(Reelmaster 216-D)
1. Cutting unit clutch (Reel) switch (Item 24)
Reelmaster
®
216/216-D Page 6 - 23 Testing