Skid Kit Installation
1. Remove front roller from the cutting unit (see Roller
Removal and Installation).
2. Align skid slots with the angle bracket holes on the
cutting unit.
3. Secure skid to the cutting unit with both flange head
screws, flat washers, and lock nuts.
4. Adjust skid height as necessary by loosening lock
nuts and flange head screws, then retighten fasteners.
3
1
4
5
2
Figure 30
1. Skid
4. Flat washer
2. Angle bracket holes
5. Lock nut
3. Flange head screw
Cutting Units Page 7 – 26 Reelmaster 2300–D/2600–D
To Next Page
Loading...
