1
2
3
4
5
6
7
8
9
10
16
17
18
19
20
21
22
23
11
12
13
14
15
8
24*
25*
25*
24
PLUG
24*
SHUTTLE
SPRING
(PLUG)
24* (PLUG)
*LEFT HAND MOTOR ONLY
VALVE
Figure 32
1. Dirt and water seal
10. Inner bearing
18. Wear plate
2. Outer bearing
11. Coupling shaft
19. Rotor
3. Housing
12. Thrust bearing
20. Vane
4. Backup washer
13. Drive link
21. Stator
5. Seal ring
14. Cap
screw
22. Manifold
6. Backup washer
15. Commutator seal
23. Commutator ring
7. Inner seal
16. Commutator
24. End cover assembly
8. Thrust washer
17. W
oodruff key
25. O–ring
9. Thrust bearing
Disassembly (Fig. 32)
If the wheel motor is not held firmly in the
vise, it could dislodge during service and
1.
firmly on the sides of the housing (3).
2. Scribe an alignment mark down and across the
cause injury.
WARNING
Place wheel motor in a soft jawed vice with the cou-
pling shaft (11) pointed down and the vise jaws clamping
wheel motor components from the end cover (24) to the
Figure 33
housing (3) for facilitating reassembly (Fig. 33). If in-
cluded in end cover, loosen both shuttle valve plugs
3. Remove seven cap screws (14). Remove end cover
(left–hand motor only) for disassembly later.
assembly (24) and seal ring (5).
Hydraulic System Page 4 – 46 Reelmaster 2300–D/2600–D
To Next Page
Loading...
