__________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
All Cutting Units Operate Slowly
Cause Correction
Low engine RPM. Adjust engine rpm - use tachometer.
Hydraulic oil level too low. Fill to proper level.
Bedknife to reel contact too tight. Adjust bedknife to reel contact.
Reel speed control linkage damaged or out of Repair or adjust control linkage as necessary.
adjustment.
Charge pressure low in with machine moving and Inspect charge relief valve and adjust or repair if nec-
cutting units engaged - TEST NO. 8. essary.
NOTE: Traction circuit will also be affected.
Inspect auxiliary pump and repair or replace if neces-
sary NOTE: Steering and lift will also be affected if
auxiliary pump is damaged.
Mowing circuit pressure too low - TEST NO. 3. Inspect mowing circuit pump check/relief valves and
repair
or replace if necessary.
Check for damaged pump and repair or replace if
necessary.
Mowing circuit flow too low - TEST NO. 4. Check for damaged pump and repair or replace if
neces
sary.
Troubleshooting P
age 4 - 18 Reelmaster
®
335-D
To Next Page
Loading...
