__________________________________________________________________________________________
__________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
Cutting Unit(s) Lower or Raise Too Quickly
Cause Correction
Missing or improperly installed cylinder port orifice. Properly install orifice between fitting and lift port of
hyd
raulic lift cylinder(s). NOTE: Orifice must be in-
stalled at least 10 - 12 revolutions to avoid interfer-
ence with adapter fitting.
Steering Loss
Cause Correction
Steering linkage or cylinder pivots damaged, worn, Lubricate bushings. Inspect for damage. Repair or re-
or
binding. place damaged parts.
Low steering pressure - TEST NO. 6. Check for restriction in pump intake line or strainer
and
repair if necessary.
Check steering cylinder for internal leakage and re-
pair or replace if necessary.
Clean relief valve in steering pump and adjust or re-
place if necessary.
Inspect steering/lift pump for wear or damage and re-
pair or replace if necessary.
Steering control unit faulty. Repair or replace steering control unit.
NOTE: Steering loss after washing machine can be the result of “thermal shock”. Normal functions will return after
ste
ering control unit temperature stabilizes. To prevent damage to steering control unit, DO NOT attempt to turn
steering wheel until temperature stabilizes when thermal shock is noted.
Troubleshooting P
age 4 - 22 Reelmaster
®
335-D
To Next Page
Loading...
