___________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
General Run and Transport Problems (continued)
Condition Possible Cause Correction
4WD does not engage. Axle in Hi range. Axle must be in Low range for
4WD to engage.
Axle HI/Low switch faulty. Test HI/Low switch. Replace
switch if faulty. Make sure switch
is screwed all the way in.
Axle Hi/Low switch wiring loose, Repair wiring.
corroded or damaged.
4WD solenoid valve faulty. Test 4WD solenoid valve. Re-
place if faulty.
4WD solenoid wiring loose, cor- Repair wiring.
roded or damaged.
Problem is not electrical. See Troubleshooting section of
Chapter 4 - Hydraulic System.
Battery does not charge. L
oose or broken wire(s). Repair wiring.
Faulty alternator. Check alternator belt tension.
Test alternator and replace if
faulty.
Dead battery. Charge battery. Replace battery if
it will not hold a charge.
Reelmaster
®
335-D Page 5 - 11 Troubleshooting
To Next Page
Loading...
