Fuses
The electrical system is protected by twelve (4) fuses
located under the control panel to the operator’s right.
NOTE: It is not always possible to see if a fuse is faulty.
It
is recommended that you check for faulty fuses with
a continuity tester, not visually.
The starter circuit is also protected by a 30 amp in-line
fu
se between the start relay and starter solenoid.
1
2
4
Figure 31
1. ACC fuse 3. REEL fuse
2. RELAY fuse 4. RUN fuse
FUSES
1. ACC 5A
2. RELAY 5A
3. REEL 30A
4. RUN 15A
Repairs Page 5 - 28 Reelmaster
®
335-D
To Next Page
Loading...
