Installing Axle on Machine
1. Support axle under machine with a jack.
2. Install axle pivot pin to secure axle to frame. Make
s
ure to install thrust washers between axle pivot and
frame.
3. Install hydraulic motor to adaptor housing.
4. Install wheels to axle. Tighten lug nuts to a torque of
45 - 55 ft-lb.
5. Fill axle with SAE 80-90W EP gear lube. Lubricant
capacity is approximately 80 oz. (2.5 U.S. qt.).
6. Check rear wheel toe-in and adjust if necessary.
Rear wheel toe-in 0.25 in.
Reelmaster
®
335-D Page 6 - 21 Repairs
To Next Page
Loading...
