Toro REELMASTER 3500-D - Roller Removal and Installation

Roller Removal and Installation
1. Remove the fasteners securing the guard and roller
adjustment housing to the side plate (Fig. 24) or un-
screw the upper cone nut and drop the threaded rod out
of the adjustment housing (Fig. 25).
2. The threaded rod and collar assembly can be re-
move
d from the roller by sliding it off the shaft at both
ends (Fig. 25).
IMPORTANT: When assembling a new roller to the
c
utting unit mount the roller so that the roller shaft
“locknut” is on the right side of the cutting unit
(Fig. 25). (As viewed by the operator sitting on seat
of machine). This prevents the lock nut from loos-
ening during operation.
Figure 24
1. Guard
2. Roller adjustment housing
3. Side plate
4. Mounting fasteners
Figure 25
1. Cone nut
2. Rod and collar assembly
3. Flex locknut
Repairs Page 7 - 16 Reelmaster
®
335-D