Reelmaster 3550--D
DPA Cutting Units
Page 7 -- 6
Spline Insert Tool
Toro Part Number: TOR4112 (8 tooth)
Use the spline insert tool for rotating the cutting reel
when hydraulic motor is removed. Also, use this tool for
installation of threaded inserts into the cutting reel shaft.
Figure 8
Roller Rebuild Kit
Toro Part Number: 115--0803
This tool kit is used to assemble the cutting unit rollers.
Tools in this kit are also available individually as follows:
115-- 0852 Inner Seal Tool
115--0853 Bearing/Outer Seal Tool
107--8133 Bearing Installation Washer
Figure 9
Inner Seal
Tool
Bearing/Outer Seal
Bearing Installation
Washer
Tool
Diameter/Circumference Measuring Tape
Spring steel measuring tape for accurately measuring
the circumference and outside diameter of cutting reel
and other spherical components. Tape calibration is in
fixed inch readings (no adjustments).
Toro Part Number: TOR6023
Figure 10
To Next Page
Loading...
