Reelmaster 3550--D/3555--D/3575--D
DPA Cutting Units
Page 7 -- 8
Pulley Alignment Tool
Toro Part Number: 114--5446
Use pulley alignment tool to verify alignment of groomer
and/or rear roller brush drive and driven pulleys.
Figure 16
Diameter/Circumference Measuring Tape
Spring steel measuring tape for accurately measuring
the circumference and outside diameter of cutting reel
and other spherical components. Tape calibration is in
fixed inch readings (no adjustments).
Toro Part Number: TOR6023
Figure 17
Turf Evaluator Tool
Toro Model Number: 04399
Many turf discrepancies are subtle and require closer
examination. In these instances, the Turf Evaluator
grass viewing tool is helpful. It can assist turf managers
and service technicians in determining causes for poor
reel mower performance and in comparing the effective
height--of--cut of one mowed surface to another.
NOTE: For additional information regarding aftercut
appearance, a number of Reel Mower and Aftercut Ap-
pearance General Training Books can be found on the
Service Reference Set available from your Authorized
Toro Distributor.
Figure 18
To Next Page
Loading...
