Reelmaster 3550--D/3555--D/3575--D
DPA Cutting Units
Page 7 -- 12
Factor
Possible Problem/Correction
Cutting unit alignment and carrier frame ground
following
Check carrier frames and lift arms for damage, binding
conditions or bushing wear. Repair if necessary.
Roller condition and roller type Make sure that front and rear rollers rotate freely.
Repair roller bearings as necessary.
See Roller Service in the Service and Repairs section
of this chapter.
Refer to Cutting Unit Operator’s Manual for roller
options.
Turf compensation spring adjustment Refer to Traction Unit Operator’s Manual for
adjustment procedures.
Rear lift arm counterbalance spring adjustment Refer to Traction Unit Operator’s Manual for
adjustment procedures.
Cutting unit accessories A variety of cutting unit accessories are available that
can be used to enhance aftercut appearance. Refer to
Operator’s Manual for a listing of available
accessories.
To Next Page
Loading...
