Reelmaster 3550--D/3555--D/3575--D
DPA Cutting Units
Page 7 -- 16
5. Remove caps or plugs f rom fittings and hoses.
IMPORTANT: When installing the hydraulic hoses,
make sure that hydraulic hoses a re straight (not twisted)
before tightening the hoses to the motor fittings.
6. Lubricate and install new O--rings on motor fittings.
Correctly connect hydraulic hoses to the motor using la-
bels placed during removal procedure.
7. Check oil level in h ydraulic reservoir and add correct
oil if necessary.
8. Follow Hydraulic System Start--up procedures (see
Hydraulic System Start--up in this section).
To Next Page
Loading...
