Reelmaster 3550−D/3555−D/3575−D Hydraulic SystemPage 4 − 41
7. Slowly depress forward traction pedal until 1000 to
1500 PSI (68.9 to 103.4 Bar) is displayed on the pres-
sure gauge.
Flow meter should read less than 1.5 GPM (5.7
LPM).
8. Release traction pedal, shut engine off, and record
test results.
9. Rotate rear wheel 120 degrees and retest. Repeat
this procedure until wheel motor has been tested in
three (3) different positions.
10.If specifications are not met, repair or replace worn
wheel motor.
Hydraulic
System
To Next Page
Loading...
