Toro Reelmaster
4000?D - Page 114

Reelmaster 4000−DPage 4 − 82Hydraulic System
6. Remove 2 pins and 2 springs from balance ring as-
sembly, see Fig. 75.
7. Remove balance ring assembly.
8. Remove inner and outer face seals from balance ring.
9. Remove the valve.
10. Remove the valve plate.
11. Remove the 3[76] diameter seal from valve plate.
12. Remove the valve drive.
13. Remove the Geroter. Be sure to retain the rollers in
the outer ring if they are loose.
14. Remove the drive.
15. Remove the 3[76] diameter seal from wear plate,
see Fig. 77.
16. Remove the wear plate.
17. Remove the shaft face seal from the wear plate.
18. Remove the 3[76] diameter seal from bearing hous-
ing.
Figure 75
Figure 76
Figure 77
Figure 78