Figure 24
Floating or Fixed Head Kit Pivots
(Floating Head Kit Shown)
Figure 25
Reel & Roller Bearings
LUBRICATION
Areas to lubricate are pictured in figures 23–25.
Use No. 2 lithium-based grease. Also, grease
the fitting on the Reel Control Valve (not
shown), under the right console.
Note: Remove the plastic caps over the fittings
on the floating- or fixed-head kit pivots and
replace them after greasing (Fig. 24).
Figure 22
Lift Arms (5 fittings)
Figure 23
Rear Axle (3 fittings)
To Next Page
Loading...
