Reelmaster 5010- HPage 6 - 6Chassis
Steering Column
1. Steering column
2. Steering wheel
3. Steering wheel cover
4. Lock nut
5. Flat washer
6. Socket head screw (4 used)
7. Steering control valve
8. Column brace
9. Flange nut (6 used)
10. Flange head screw (2 used)
11. Socket head screw (4 used)
12. O- ring
13. Hydraulic fitting (4 used)
14. O- ring
Figure 4
FRONT
RIGHT
1
13
14
10
11
5
9
2
3
12
9
7
4
6
8
20 to 26 ft- lb
(28 to 35 N- m)
Antiseize
Lubricant
Antiseize
Lubricant
Removal (Fig. 4)
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. Remove cover from steering wheel by carefully pry-
ing up on one of the cover spokes.
3. Remove lock nut and flat washer that secure steer-
ing wheel to steering column.
4. Use a suitable puller to r emove steering wheel from
steering column.
5. Remove platform shroud from machine to allow ac-
cess to steering column fasteners (Fig. 5).
A. Remove cover plate from platform.
B. Remove fasteners t hat secure platform shroud to
machine and remove platform shroud
C. Retrieve two (2) rubber bushings and spacers.
To Next Page
Loading...
