Backlapping the Cutting Units (continued)
Note: Burrs or rough edges may result from lapping the cutting edge. For a better
cutting edge, file across the cutting edge 90º to the front face of the bedknife to remove
the burrs.
6. Adjust the cutting unit reel to bedknife as needed.
7. Adjust the cutting unit reel speed to the desired mowing setting.
Chassis Maintenance
Inspecting the Seat Belt
1. Inspect the seat belt for wear, cuts, and other damage. Replace the seat belt(s) if any
component does not operate properly.
2. Clean the seat belt as necessary.
Cleaning
Washing the Machine
Wash the machine as needed using water alone or with a mild detergent. You may use a rag
when washing the machine.
IMPORTANT
• Do not use brackish or reclaimed water to clean the machine.
• Do not use power-washing equipment to wash the machine. Power-washing
equipment may damage the electrical system, loosen important decals, or wash
away necessary grease at friction points. Avoid excessive use of water near the
control panel, engine, and battery.
• Do not wash the machine with the engine running. Washing the machine with the
engine running may result in internal engine damage.
Maintenance: Chassis Maintenance Page 6–43 3464-478 A
To Next Page
Loading...
